How To Remove Rear Drive Shaft Jeep Wrangler? (Solution found)

  • Remove the four bolts that hold the U-joint straps to the rear axle yoke in place on the yoke. Pushing the driveshaft forward will cause the rear of the shaft to be pushed down. Draw the shaft towards the direction of the rear axle. It’s out in the open. To become a WranglerForum Supporting Member, please click HERE.

Can I drive my JK without a front drive shaft?

You will be ok as long as you do not tow the vehicle. If my recollection serves me correctly, the front drive shaft rotating when the Jeep is not running is what lubricates the T-case. When towing, there is a particular Trans, T-case option. I operated mine without a front shaft for a lengthy period of time while attempting to isolate a vibration source.

Can you remove the rear drive shaft and still drive?

Is it possible to operate a 4WD vehicle without using the front or back driveshafts? In fact, driving a standard 4WD vehicle with a locking center differential is doable in some situations. Remove the damaged drive shaft and lock the center differential to prevent it from spinning again. This will allow the transfer box to send power to either the front or rear driveshafts, depending on which direction the vehicle is traveling.

How long does it take to replace rear drive shaft?

It should not take more than two hours of work to complete the task. In the majority of situations, replacing a drive shaft will take roughly an hour. This indicates that the entire cost, including labor and components, will be in the range of $400 to $1500. Because it is not a particularly difficult task, you might save a few dollars by changing the driveshaft yourself.

You might be interested:  What Year Jeep Wrangler Is Most Reliable? (Correct answer)

What does slip yoke eliminator do?

Slip Yoke and Slip Yoke Eliminator are two types of slip yoke. Because of this sliding capacity, the length may be adjusted in response to the vehicle’s motions. A slip yoke eliminator, often known as a SYE, is a device that performs exactly what its name suggests: it removes the slip yoke from the transmission. The result is that the yoke becomes fixed and does not slip.

Leave a Comment

Your email address will not be published. Required fields are marked *